Verteq 1600-55A

VERTEQ 1600-55A SINGLE STACK SRD consisting of:

- Model: 1600-55A
- Single Stack SRD
- Up to 6"/150mm Wafer Capable
- Resistivity Monitor
- Operations Manual
- Power: 120v, 50/60hz

CLASSONE''S VERTEQ SRD REFURBISHMENT PROCESS consists of:

- Bowls are sent out for electro-polishing for like new condition.
- NEW Solenoids Valves are installed (ClassOne Standard).
- NEW Door Seals are installed (ClassOne Standard).
- NEW Vibration Isolators are installed (ClassOne Standard).
- NEW N2 Filters are installed (ClassOne Standard).
- NEW Rear Bowl Seals are installed (ClassOne Standard).
- All Nozzles are inspected visually, tested for spray pattern and replaced as needed.
- Rotor Stop Positioners are inspected and serviced or replaced as needed.
- Delivery lines are repaired or replaced as needed.
- Pneumatic lines are repaired or replaced as needed.
- Wiring is repaired or replaced as needed.
- If damaged electronics are found they are repaired or replaced as needed.
- Machine Covers are inspected and replaced as needed.
- Door Windows are replaced as needed.
- System Leveling Feet are replaced as needed.
- System Wheels are replaced as needed.
- During Quality Assurance testing the system is run to verify that no temp errors occur under normal operation.
- During Quality Assurance testing the system is run to verify RPM regulation and stability under normal operation.
- During Quality Assurance testing the system is run to verify that the valves both operate properly and do not leak by under normal operation.
- During Quality Assurance testing the system is run to verify without excessive vibration normal operation.
- Where applicable ferrofluidic feed-thrus are inspected and serviced as needed.
- Where applicable EMO Button(s) and Circuit(s) is tested.